please fill out the form. We're ready to receive your message.
KNX FCHC Actuator adopts KNX/EIB communication and is used for controlling air conditioner, fan, compressor and floor heating. The module function is set via ETS software and can work in conjunctions with different panels. And up to 7 digital temperature sensors can be connected.
KNX FCHC Actuator adopts KNX/EIB communication and is used for controlling air conditioner, fan, compressor and floor heating. The module function is set via ETS software and can work in conjunctions with different panels. And up to 7 digital temperature sensors can be connected.
■ Multiple control objects: HVAC, Fan, Compressor, Floor heating, one control mode for each control target.
Basic Parameters
Working voltage 21~30V DC
Working current 20mA/30V DC
Communication KNX
Cable diameter of KNX terminal 0.6 – 0.8mm
Temperature sensor Digital temperature sensor (TS/C1.0)
Output current 8A (AC) 5A (DC)
External Environment
Working temperature -5℃~45℃
Working relative humidity ≤90%
Storage temperature -20℃~60℃
Storage relative humidity ≤93%
Specifications
Dimensions 90mm×72mm×64mm
Net weight 168g
Housing material Frame-retardant nylon
Installation 35mm DIN rail installation (See Figure 6 - 8)
Protection rating (Compliant with EN 60529) IP20
KNX 4CH 10A Curtain Actuator is in full compliance with Chinese and European safety standards and KNX protocol. This series of products have the characteristics of high power (10A), low consumption and high reliability.
KNX HVAC Module belongs to HDL KNX/EIB series, and it supports control of heating, cooling, high/medium/low fan speed. 7 independent floor heating control channels can be set. In conjunction with digital temperature sensor, the actuator achieves precise temperature control. In addition, 5 switch output channels and 2 DC0-10V output channels can be set for staircase lights and other requirements.
KNX 6CH 10A 0~10V Dimming Actuator supports 6-channel 0/1-10V dimming, and each circuit is equipped with10A relay synchronous control to turn it on and off. The buttons can be manually controlled to control the switch and dimming. Both current absorbing and output ballasts can be used.